Influence of ocean salt water on mortar properties with substitution of sand by waste glass powder
DOI: 10.23977/jceup.2025.070112 | Downloads: 11 | Views: 250
Author(s)
Abidé D. Soudoukou 1, Adiza Malle 1, Wu Yankai 1, Wang Ying 1, Seabra S. Manbode 2, Eyazama F. Soudoukou 3
Affiliation(s)
1 Shandong Key Laboratory of Civil Engineering Disaster Prevention and Mitigation, College of Civil Engineering and Architecture, Shandong University of Science and Technology, Qingdao, 266590, China
2 Department of Mechatronic, Shandong University of Science and Technology, Qingdao, China
3 Department of Water and Environment Management ESTBA, University of Lomé, Lome, 1515, Togo
Corresponding Author
Abidé D. SoudoukouABSTRACT
The construction sector, particularly in countries bordering the ocean, is faced with a major challenge: effectively reusing waste of all kinds to limit pollution and build structures capable of withstanding the environment's long-term acidity (pH). Using waste glass as a finely ground mineral additive in a mortar is a promising recycling route based on the mechanical-chemical activation method. This article presents the research results into using glass powder, which is very recent and rare, as a partial replacement for sand, with a substitution level of 0% to 10%. This work studies the influence of waste glass powder (wgp) and salt water (sw) on mortar's flexural and compressive strength. The physical properties such as porosity, absorption rate, and their micro mechanical-chemical behaviour were also studied. The experimental results showed that the flexural strength of those with glass sand increased with salt water. On the other hand, the Unconfined compressive strength also increased, so the recycled glass aggregate can be used for producing coatings or self-compacting concrete.
KEYWORDS
Waste Glass Powder; Salt Water; Absorption Rate; Unconfined Compressive Strength; Flexural Strength; PorosityCITE THIS PAPER
Abidé D. Soudoukou, Adiza Malle, Wu Yankai, Wang Ying, Seabra S. Manbode, Eyazama F. Soudoukou, Influence of ocean salt water on mortar properties with substitution of sand by waste glass powder. Journal of Civil Engineering and Urban Planning (2025) Vol. 7: 91-96. DOI: http://dx.doi.org/10.23977/jceup.2025.070112.
REFERENCES
[1] Liu Z. (2018) Overview of waste glass recycling in China. Glass, vol. 45, no. 10, pp. 1-8.
[2] Idir R., Cyr M., and Tagnit-Hamou A. (2010) Use of fine glass as ASR inhibitor in glass aggregate mortars. Construction and Building Materials, vol. 24, no. 7, pp. 1309-1312.
[3] Kou S. C., and Poon C. S. (2009) Properties of self-compacting concrete prepared with recycled glass aggregate. Cement and Concrete Composites, vol. 31, no. 2, pp. 107-113.
[4] Ling T.-C., and Poon C.-S. (2011) Properties of architectural mortar prepared with recycled glass with different particle sizes. Materials & Design, vol. 32, no. 5, pp. 2675-2684.
[5] Ling T.-C., Poon C.-S., and Kou S.-C. (2011) Feasibility of using recycled glass in architectural cement mortars. Cement and Concrete Composites, vol. 33, no. 8, pp. 848-854.
[6] Penacho P., de Brito J., and Veiga M. R. (2014) Physico-mechanical and performance characterization of mortars incorporating fine glass waste aggregate. Cement and Concrete Composites, vol. 50, pp. 47-59.
[7] Shayan A., and Xu A. (2004) Value-added utilisation of waste glass in concrete. Cement and concrete research, vol. 34, no. 1, pp. 81-89.
[8] Sara de Castro, and Brito J. d. (2013) Evaluation of the durability of concrete made with crushed glass aggregates. Journal of Cleaner Production, vol. 41, pp. 7-14.
[9] Limbachiya M. C. (2009) Bulk engineering and durability properties of washed glass sand concrete. Construction and Building Materials, vol. 23, no. 2, pp. 1078-1083.
[10] Xuan D., Tang P., and Poon C. S. (2019) MSWIBA-based cellular alkali-activated concrete incorporating waste glass powder. Cement and Concrete Composites, vol. 95, pp. 128-136.
[11] Metwally I. M. (2007) Investigations on the performance of concrete made with blended finely milled waste glass. Advances in structural engineering, vol. 10, no. 1, pp. 47-53.
[12] Yahia S., Cheikh Z., Hicham S., and Zouhir Y. M. Comparison between the American standard and the RILEM recommendation for the calculation of the porosity of mortars. Journal of Advanced Research in Materials Science vol. 34, no. Issue 1 (2017) 8-15, pp. 8.
[13] Qu F., Li W., Dong W., Tam V. W., and Yu T. (2021) Durability deterioration of concrete under marine environment from material to structure: A critical review. Journal of Building Engineering, vol. 35, pp. 102074.
[14] Ragab A. M., Elgammal M. A., Hodhod O. A., and Ahmed T. E. (2016) Evaluation of field concrete deterioration under real conditions of seawater attack. Construction and Building Materials, vol. 119, pp. 130-144.
[15] Achal A., and Chandak N. (2017) Effect of Salt Water on Mechanical Properties of Conventional and Pervious Concrete. IOSR Journal of Mechanical and Civil Engineering (IOSR-JMCE) e-ISSN, pp. 2278-1684.
[16] Du H., and Tan K. H. (2014) Waste glass powder as cement replacement in concrete. Journal of Advanced Concrete Technology, vol. 12, no. 11, pp. 468-477.
[17] Ammash H. K., Muhammed M. S., and Nahhab A. H. (2009) Using of waste glass as fine aggregate in concrete. Al-Qadisiya Journal For Engineering Sciences, vol. 2.
[18] Griffin D. F., and Henry R. L., The effect of salt in concrete on compressive strength, water vapor transmission, and corrosion of reinforcing steel: US Naval Civil Engineering Laboratory Port Hueneme, CA, 1964.
Downloads: | 10685 |
---|---|
Visits: | 337799 |
Sponsors, Associates, and Links
-
Journal of Sustainable Development and Green Buildings
-
Landscape and Urban Horticulture
-
Bridge and Structural Engineering
-
Soil Mechanics and Geotechnical Engineering
-
Journal of Municipal Engineering
-
Heating, Ventilation and Air Conditioning
-
Indoor Air Quality and Climate
-
Computer Aided Architecture Design