Bentonite-Loaded Chitosan Adsorption Treatment of Cu2 + in Aqueous Solution
DOI: 10.23977/jmpd.2020.040101 | Downloads: 44 | Views: 3608
Author(s)
Longjiang Liu 1,2, Pengzhi Xiang 1,2, Jun Shen 1,2
Affiliation(s)
1 School of Chemical Engineering, Yunnan Open University Kunming 650500, China
2 College of Chemical Engineering, Yunnan National Defense Industry Vocational and Technical College Kunming 650500, China
Corresponding Author
Pengzhi XiangABSTRACT
A modified chitosan-bentonite composite adsorbent has been prepared by loading chitosan using bentonite as a carrier, and the modified bentonite has been characterized by scanning electron microscope (SEM) analysis and thermogravimetric (TG) analysis. The prepared chitosan-bentonite is used to remove copper ions in aqueous solution. The effects of reaction time, pH value, initial concentration of copper ions and addition amount of bentonite-loaded chitosan adsorbent on the adsorption effect were investigated. In this experiment, the single-factor investigation of the adsorption of copper ions by this material showed that: when the mass ratio of chitosan and bentonite is 0.08: 1, the adsorption effect of copper ions is better when the time is 50min, pH=11 and the adsorption temperature is 20℃ the removal rate is higher, which can reach 95%. The material is green and environmentally friendly, which realizes the efficient use of chitosan and bentonite, and has certain utilization value for the removal of copper ions.
KEYWORDS
chitosan-bentonite, copper ion, adsorption treatmentCITE THIS PAPER
Longjiang Liu, Pengzhi Xiang and Jun Shen. Bentonite-Loaded Chitosan Adsorption Treatment of Cu2 + in Aqueous Solution. Journal of Materials, Processing and Design (2020) 4: 1-9. DOI: http://dx.doi.org/10.23977/jmpd.2020.040101.
REFERENCES
[1] Li Yujie, Li Yujia, Li Hongfen, et al. Adsorption characteristics of bentonite-loaded chitosan for Cu (II) in water [J]. Mineral Protection and Utilization, 2019, 39 (219,) 90-95.
[2] Wu S, JiangJ, Liang Y, et al. Chemical precipitation synthesis and thermoelectric properties of copper sulfide [J]. Journal of ElectronicMaterials, 2017, 46: 1-6.
[3] Negm N A, Sheikh R E, Elfarargy A F, et al. Treatment of industrial wastewater containing copper and cobalt ions using modifiedchitosan [J]. Journal of Industrial and Engineering Chemistry, 2015, 21: 526-534.
[4] Zhao Hefei, Yang Hongying, Zhang Qin, et al. Research status of various factors affecting gold leaching with thiosulfate [J]. Gold Science and Technology, 2018, 26 (198): 109-118.
[5] Li Jianjun, Bao Xu, Wu Xianfeng, et al. Preparation of magnetic chitosan composite microspheres and their Cu2+ adsorption properties [J]. Journal of Inorganic Chemistry, 2017, 33 (3): 383-388.
[6] Pan Tao; Yu Tao; Li Song. Study on the adsorption behavior of copper on sodium bentonite [J]. Guangzhou Chemical Industry, 2017, 45, 53-56.
[7] Zhang Dejin; Liu Sai; Shen Jian, et al. Study on the adsorption performance of modified bentonite for nickel ion [J]. Journal of Dezhou University, 2019, 35 (164): 26-29.
[8] Yang Cuina, Ding Shuli. Study on the adsorption properties of bentonite to Cu~(2+) in wastewater [J]. Journal of Hebei University of Engineering (Natural Science Edition), 2011, 28 (93): 77-80.
[9] Yuan Yue; Qian Benxiang; Ling Xinlong. Research progress and application of modification of chitosan [J]. Journal of Textile Science and Engineering, 2019, 85-92.
[10] Zhang Lihua, Wang Junqin, Yang Mao, et al. Dissolution, materialization and derivatization of chitin and chitosan in ionic liquids [J]. Science in China: Chemistry, 1-14.
[11] Gao Yuchao, Pan Junbiao, Wang Chuangyi, et al. Bentonite-based chitosan adsorbent for the treatment of Pb (Ⅱ) and Cd (Ⅱ) in wastewater.Nonmetallic ore, 2018, 41 (1): 98-100.
[12] Zhai Jiaying. Experimental study on the treatment of zinc-containing wastewater by bentonite-loaded chitosan adsorbent [J]. Environmental Protection and Circular Economy, 2019, 20-22.
[13] Sreedharan V, Sivapullaiah p V. Effect of organic modifi-cationon adsorption behaviour of bentonite [J] Indiangeotechnicaljournal, 2012, 42 (3): 161-168.
[14]Dalida M L P. Mariano A F V, Futalan C M.et al. Ad-sorptive. Removal of Cu(I) from aqueoussolutions usingnon – crosslinked and crosslinkedchitosan – coated bentonite beads [J]. Desalination, 2011, 275 (1-3): 154-159.
[15] Tang Rui; Wang Zhongkai; Liu Kun et al. Competitive adsorption of Cu (Ⅱ), Cd (Ⅱ) and Mn (Ⅱ) by magnetic organic bentonite [J]. Nonmetallic Minerals, 2019, 42 (255): 83-87.
Downloads: | 2566 |
---|---|
Visits: | 126597 |
Sponsors, Associates, and Links
-
Forging and Forming
-
Composites and Nano Engineering
-
Metallic foams
-
Smart Structures, Materials and Systems
-
Chemistry and Physics of Polymers
-
Analytical Chemistry: A Journal
-
Modern Physical Chemistry Research
-
Inorganic Chemistry: A Journal
-
Organic Chemistry: A Journal
-
Progress in Materials Chemistry and Physics
-
Transactions on Industrial Catalysis
-
Fuels and Combustion
-
Casting, Welding and Solidification
-
Journal of Membrane Technology
-
Journal of Heat Treatment and Surface Engineering
-
Trends in Biochemical Engineering
-
Ceramic and Glass Technology
-
Transactions on Metals and Alloys
-
High Performance Structures and Materials
-
Rheology Letters
-
Plasticity Frontiers
-
Corrosion and Wear of Materials
-
Fluids, Heat and Mass Transfer
-
International Journal of Geochemistry
-
Diamond and Carbon Materials
-
Advances in Magnetism and Magnetic Materials
-
Advances in Fuel Cell
-
Journal of Biomaterials and Biomechanics